Loading..

I'M LOOKING FOR

SELECT

Alternator
OR
Starter Motor
FIND YOUR VEHICLE
Please provide your vehicle registration or enter your vehicle details above. If you have any part numbers from your old part, you can find that part using the search box at the top

Charging Sytems: Generator / Alternator / Dynamo

There is a charging system in each car, and it is there to recharge the battery and to supply the whole car with electric current and power. In most modern cars an Alternator is fitted to provide electrical power, but in old cars you can still find that a Dynamo with a regulator or control box does the job that an Alternator does with an built in regulator or external regulator, and in some cases on even newer cars the Alternator is controlled by the Electronic Control Unit or ECU. The ECU can decide to increase or reduce the output of the Alternator, to help efficiency, acceleration and even emission control.

If your Alternator is faulty, various symptoms can occur from simply having a flat battery, warning lights appearing, noises from the bearings or pulley and even overcharging. Nowadays it is not always the case that the battery warning light on the dash meaning a straightforward Alternator replacement is needed, often on modern cars the battery warning light is computer controlled and the Alternator receives a digital or computer signal from the main electronic control unit. It is important to diagnose a charging fault carefully so that you only buy the part you need, avoiding an expensive repair is where we at startermotoralternator.com can help. All our parts are high quality and competitively priced.

Remember to disconnect the battery when working on you Alternator and ensure that you mark clearly where wires and connector plugs are removed so that you refit them in the correct place. You should always charge your battery before fitting a replacement Alternator. If you are unsure always seek the advice of a specialist. A specialist or mechanic or auto electrician, will also help you identify the cause of failure as well as identifying the part that needs replacing. In a lot of cases another problem on your vehicle may have caused the failure of the Alternator, and these can include pulley damage or failure due to a faulty tensioner, burn out due to poor battery, excessive drive belt dust and corroded or poor connections. All our products come with technical notes to help where there are known common faults to help you fix your Alternator issues first time.

Below are some of the most common Alternator failures

  • slip rings are soiled, burned or oiled
  • drive belt slipping
  • excitation circuit is broken or incomplete
  • bearings are worn-out or damaged
  • pulley of the alternator is loosened or pulley clutch has failed
  • internal windings burn out
  • bracket seat is worn-out, broken or cracked
  • periodical brushes jamming, or stuck due to ingress or overheat

Signs of alternator failures

  • battery is discharged or boils away;
  • excessive noise when the unit starts working;
  • warning lights or message indicating low charge battery
  • dim headlights;
  • squealing belt noise
  • alternator charging when engine revs are increased

Diagnostics and fault finding The diagnostics of the unit should be carried out with the help of the ammeter and the voltmeter. It is possible to do it yourself or with help of a specialist. A poor earth or main feed from the battery must also be considered, it is important to check the old part you remove for the warning signs of failure, and if there is another fault on your vehicle it will need rectification otherwise it will cause your newly fitted replacement to fail prematurely.

Serviceable Life of an Alternator Usually the alternator service life is about 100,000 miles. However this depends on the actual type of use and the application, as some Alternators do not last as long as others due to their design or high demand. Normally the drive belt is replaced at the same time as a replacement Alternator is fitted.

Starting Systems: Starter Motor

A Starter Motor serves to start internal-combustion engine. Approximately all motor cars use starters with the mechanical inertia drive. When the driver switches on the ignition, the drive gear on the Starter Motor starts to interact with the engine flywheel ring gear. The drive gear is controlled by the solenoid. Older designed Starter Motors have a separate solenoid switch usually mounted on the bulkhead, but most newer cars have a Starter Motor and solenoid together. Later Starter Motors are much smaller than ones fitted to older cars, but actually have more power due to the geared design and save weight which makes them far more efficient. Stop Start systems have meant that Starter Motors now have had to become more robust, so it is important that you fit the correct Starter Motor and not guess or buy the cheapest, because it won’t last. Here at startermotoralternator.com, you can check for the right part you need on our website, and see an actual picture so you are sure it matches plus all our parts are high quality and competitively priced.

There may be a lot of reasons why the Starter Motor does not work. Obvious problems are burn out, sticking pinion or drive, clicking and faulty ignition switch. Sometimes a faulty Alternator that has not charged a battery can give the symptoms of a Starter Motor that needs replacing, so it is really important to check first. When you remove your old Starter Motor, you will need to check visually for signs that it is needing replacing, and these could be the overheating of wires or terminals and build-up of contamination around the drive or pinion area. A specialist or mechanic or auto electrician, will also help you identify the cause of failure as well as identifying the part that needs replacing. A specialist or mechanic or auto electrician, will also help you identify the cause of failure as well as identifying the part that needs replacing. In a lot of cases another problem on your vehicle may have caused the failure of the Starter Motor, and these can include pinion damage or burn out failure due to excessive cranking, excessive dust causing contamination on the armature shaft causing the drive pinion to stick and corroded or poor connections. All our products come with technical notes to help where there are known common faults to help you fix your Starter Motor issues first time

Starter Motor failures

  • worn-out brushes;
  • overheated armature;
  • ingress of water or dust;
  • worn-out rim teeth of the flywheel or the pinion;
  • poor connections;
  • broken nose cone;
  • burned wires from body to solenoid;
  • worn-out bearings or bushes.

Signs of starter failures

  • unusual sounds when cranking;
  • lack of starter response;
  • the starter continues to run after the engine start;
  • Starter Motor turns but the engine does not start.

Starter Motor failure causes

  • Ignition switch fault;
  • battery terminals oxidation;
  • bad earth or main feed;
  • poor contact between one and/or several brushes;
  • connectors of wires are badly tightened;
  • clutch or dual mass flywheel dust contamination;
  • damaged flywheel teeth;
  • poor battery.

Diagnostics

A Starter Motor needs replacing if it stops working but correct diagnosis will ensure that you fit the correct part, so it is important to check the old part you remove for the warning signs of failure, and if there is another fault on your vehicle it will need rectification otherwise it will cause your newly fitted replacement to fail prematurely.

Serviceable Life of a Starter Motor Usually the Starter Motor service life is anywhere around 100,000 miles. However this depends on the actual type of use and the application, some do not last as long as others due to their design or high demand and Stop Start technology means that Starter Motors are increasing used more than ever before.

To Top